SPC flooring stands for Stone Plastic Composite flooring, is a high-tech research and development of new ground decorative materials, the use of natural marble powder to form a high-density of the solid base, the surface is covered with super-strong wear-resistant polymer PVC wear layer, after Hundreds of procedures to process and become. The product pattern is realistic and beautiful, super wear-resistant, the surface is bright and not slippery, which is a model of new high-tech materials in the 21st century!
What is SPC flooring made of?
Limestone (Calcium Carbonate)
PVC Resin Powder
DOTP(Plasticizer)
Stabilizer (Ca/Zn)
Stearine
Pulverizing material
PE wax / Carbon black
ACR / CPE
NOTICE: Based on the above formula of each manufacturer is slightly different.
Main equipment to produce SPC flooring
Mixing and Heating Line
Extruding Line
Hot Pressing Line
SPC Production Line
UV Coating Line
Annealing Line
Multi-Blade Sawing Line
HOMAG Profiling Line
Painted Bevel Line
SPC flooring production process
Mixing materials
Put the PVC resin powder, plasticizer, stabilizer, and carbon black into the mixer according to the formula ratio, and the machine automatically adds the plasticizer. add limestone powder, stir for about 30 minutes, and send the evenly mixed mixture to the conveyor belt and enter the internal mixer for heating and mixing.
Extruding blocks
The raw material powder enters the roller, and gradually forms after being rolled by the roller. The temperature is about 170°C. Finally, the raw material is cooled and refined, will be produced into the middle base layer and bottom base layer through the dense refining, and the raw material is cut into 1*1m or 1*1.3m blocks.
Film laying
Spread canvas, embossed board, soft film (matt film, high-temperature paper), bottom/middle material, wear-resistant layer, color film, and soft film (matt film, high-temperature paper) on the steel plate in sequence.
Hot pressing
After being pressed with another steel plate, it is sent to the hot press, continuously heated and pressurized, and taken out after about 40 minutes. After the soft film is torn off, the floor is pressed into shape. After hot pressing, the product layer is firmly bonded to the layer.
UV coating
Put the pressed whole floor into the conveyor belt, apply a layer of UV paint uniformly by the roller, and then receive ultraviolet radiation and enter the oven for baking.
In this process, the UV paint will be applied twice, and the ultraviolet radiation will be applied twice. The purpose of UV paint is to increase the gloss to meet customer requirements (the brightness of the floor is not directly related to the amount of UV paint, mainly controlled by the brightness of the UV paint).
Annealing
After the paint is fully cured, the floor is sent to cold water to cool. Finally, use a cooler to dry the water on the surface. Finally, put it into the normal temperature and normal state of being.
The purpose of tempering is to strengthen the shrinkage and warpage of the PVC floor through heating and cooling on the assembly line.
Shaped the floor
The floor is heated by the machine to make it easier to punch. Forming different shapes.
Profiling
Profiling is carried out according to customer requirements. Adjusted by the knife adjuster according to the size of the floor. After adjustment, put the pieces of the floor on the conveyor belt, first profiling the long side, then the short side.
Profiling machine guarantees the high accuracy of click products.
Groove engraving of the floor
After engraving the groove, the texture of the product imitating wood/stone/carpet texture is more realistic.
Package
The floor inspects and does the final cleaning before entering the box. In particular, it is necessary to remove obvious scratches, impurities, dirt, bubbles, color difference, discoloration, white edges, delamination, folding, bevel, residual angle, etc. failed products.
Finally seals the box, check the label, and mark content accurately.
Post time: Jun-10-2022